Jeep Wrangler Bumpers

Tough Enough To Take The Terrain

Bumpers are an important part of any vehicle, and Jeep Wranglers are no exception. In fact, they are more important because of the terrain that Jeepers like to ride through. The bumper on a Jeep Wrangler has to be tough enough to handle the roughest conditions, whether it's a front bumper or a rear one. We have a wide range of tough Jeep bumpers, including:

High Rock 4x4 High Access Front Bumper by Bestop

Available in a high-gloss black powdercoat finish or a flat black powdercoat finish, this bumper gives you a mounting surface that is flat for a winch and includes a plate for the fairlead. There are also D-ring tabs that are heavy duty, as well as the option to get a roller for the approach.

XRC Armor Rear Bumper

Made from 3/16-inch steel that has been cold rolled, this bumper offers better exit and entry because of its raised corners. It also features D-ring mounts that are solid and welded inside and out. There is a center section made from solid plate steel. This warps around the lower cross member and the horns of the frame. It is a one-piece design, and has a two-stage, matte-black finish. This model has both a hitch and a tire carrier.

XRC Armor Front Bumper by Smittybilt

This XRC bumper is also made from 3/16-inch cold roll steel. It features 1.75-inch 120 riders and kickers that are the wall-over type. The corners have been raised to allow for the greatest amount of clearance for exit and entry at any angle. It also features the center plate that wraps the lower cross member and the horns of the frame. The front bumper features a winch plate that can handle a winch rated to 10,000 lbs. This one comes in a matte-black finish.

Lifestyle Winch Bumper with Pre-runner Grille Guard by Fab Fours

For the jeeper who needs high clearance, this may be the one. Integrate D-rings and lights in a lightweight and compact unit. There are cutouts for lights and it comes with Hella 60mm turning lights and 90mm fog lights.

Full Width Front Bumper by Rock Hard 4x4 Parts

When a jeeper wants a bumper of the utmost quality, this is the one they seek. It's made from bent, laser-cut steel. It tapers back and down to protect the front sway bar disconnect and the cross frame in the lower front. This bumper gives you the greatest approach angle possible without cutting into the Jeep. If you're concerned about airflow, breathe easy. This bumper mounts the winch low. The bumper also features mounts for recessed fog lights.

Elite Series Front Bumper by Warn

The Warn Elite Series bumper features a recessed winch mount that can handle a mid-sized winch. The light ports are recessed, as are the mounts for auxiliary lights. The construction is CNC formed steel that has been laser-cut. You can get this bumper with or without the CNC formed grille tube welded to it. The bumper has recessed jack points and its mounting fasteners are on the inside.

Recovery Front Bumper with Stinger by Rampage

With this bumper, you get a no-drill installation and 1-inch Clevis shackle mounts that have been custom welded. The bumper will accept factory driving lights, and includes a winch plate along with the stinger. The bumper features floating bolts to enable easy stud alignment with the factory mounting holes.