Jeep Liberty How-To | 4WD.com
FREE SHIPPING on Orders Over $50*

Jeep Liberty How-To

How to clean mold on a Jeep top

-There are various soft top cleaners made by 303 and Bestop that are a spray-on/wipe-off cleaner. These are usually enough to do the trick without harming the top.

How to flush the radiator on a 2002 Jeep Liberty

-To flush a radiator, remove the upper and lower radiator hose. You then use the upper hose inlet. Put a hose in the inlet and run fresh water through it until the water comes out clean. It is recommended to drain into a bucket. Reinstall hoses and fill with 50/50 mix of coolant.

How to tell if transmission on Jeep is going bad

-Typically you will notice slipping or refusing to go into gear on automatics. Manual trans will refuse to go into gear, make grinding noises or just flat out be locked up.

How to tell Jeeps from other vehicles.

-You can tell a Jeep vehicle by its seven-slot grille.

How to flush the radiator on a 2002 Jeep Liberty?

-To flush a radiator, you begin by removing the upper and lower radiator hose. Then use the upper hose inlet. Put a hose in the inlet and begin running fresh water through it until the water comes out clean. It is recommended to drain into a bucket. Once done, reinstall hoses and fill with 50/50 mix of coolant.

How to get your Jeep tire cover on?

-Typically there is either elastic that just stretches over the spare tire, or there is a string going around the back of the cover. Place it on the cover and tie the string.

How to clean mold on Jeep top?

-There are various soft top cleaners made by 303 and Bestop that are a spray-on, wipe-off cleaner. These are usually enough to do the trick without harming the top.

How to tell if the transmission on Jeep is going bad.

-Typically you will notice slipping or refusing to go into gear on automatics. Manual transmissions will refuse to go into gear, make grinding noises or just flat out be locked up.

CHAT