In this Article
The rule of thumb within the 4x4 and off-road community when it comes to axles is "bigger is better". 4 Wheel Parts carries a tremendous variety of replacement axle shafts and we've learned through research and experience that there is much more to the equation than size alone.
The next time you are in the market for replacement axle shafts, there are four factors of strength you should keep in mind.
The spline count is the number of splines on the shaft or carrier. It is important that the shaft and carrier have the same spline count, or they will not fit together properly and breaking the splines is simply a matter of time.
The general consensus is: the higher the spline count, the stronger the axle. There is a lot of truth to that statement, and it is a good general rule to follow, but other factors such as spline shape, angle, material and diameter all work determine the true strength of an axle.
Not all axles are created equal. Some blends of steel are stronger than others and, generally, the stock axles are not built strong enough to handle much off-roading. There are three common material choices when it comes to axles:
A vital factor in axle strength is whether the material has undergone the hardening process or not. Hardening steel tightens the grain of the metal, resulting in a stronger end product.
"An axle is only as strong as the root of its splines," says Steven Deitsch, 4 Wheel Parts content specialist.
Axle splines come in two shapes: square and involute. Square splines are shaped precisely as you'd expect – 90 degree angles and the same width at the top of the spline as at the base. Involute splines, on the other hand, are wider at the base than at the top and have slightly curved faces for optimum contact and pressure distribution.
Square-cut splines are rarely used in modern axles, as they are much weaker than involute spines. Their shape forces the contact points between the shaft and the carrier to be very close together, causing extreme concentrations of stress and increasing the likelihood of stripping or breaking the splines.
Involute spines, on the other hand, are shaped to better distribute the stress points and are also self-centering.
Another important aspect of spline shape to keep in mind is whether the base of the splines have been undercut (pictured) or not. The down-step of the root of the splines allows for greater tensile strength in the axle.
There are two common ways for an axle shaft to be splined:
Join our mailing list to receive information on new products, special events, discounts and more!