Trail-Gear is the originator of forged high steer arms for Toyota Pickups and 4Runners. Each arm is pressure Forged from 8620 tool steel, these arms are incredibly strong. All mounting surfaces are machined including the split washer surface and the tie rod tapered holes, ensuring correct and positive contact between parts, preventing knuckle studs and tie rod ends from coming loose. Arms are angle compensated so that the rod ends ride at the factory designed 90 degree angle.
These replacement boots are made to fit Trail-Gear FJ 80 TRE, and many other popular tie rod ends. These boots are made from a special compound of UV resistant NBR (Naturally Blended Rubber) and are a direct replacement for our hi-steer TRE?s. Installation is a snap, all that is required is some grease and a pair of snap ring pliers.
Trail Gear's hydraulic steering ram mounting brackets have a 5/8in. bolt hole and are formed out of 3/16in. Steel. All Of Trail Gear's Hydro Assist Brackets are designed to fit a factory Toyota solid axle front housing or a Trail Gear Rock Assault axle housing and a 1.25in. tie rod.
If you're running a high volume/pressure pump your system is generating much more heat then the stock system. Fluid overheating can cause damage to steering pump and steering box. Installing a oil cooler in front of the radiator is the best way to prevent this over heating. Our cooler features a fin area of 9 inch X 8 inch and does a great job of keeping the steering fluid temps under control in all conditions. Mounting kit is included with the oil cooler.
Trail-Gear offers TC style power steering pump pulleys for both serpentine and v-belt style belts. All pulleys are precision CNC machined from 6061 T6 Aluminum and anodized red for a sharp look that will last for years to come. The center hole bore diameter is .660 inch and the total outside diameter of the pulley is 4 3/4 inch.