Take the guess work out of trying to wire your trailer lights with the simple plug and play trailer light adapters from Tow Ready. These adapters simply plug into the factory harness and have a convenient pig tail that your lights plug into.
wish I had found this years ago. Installed in about a half hour. I suggest using wire loom as added protection
Easy to install(No thinking required). Great product
You DON'T need a drill. Most vehicles have multiple location where you can piggy back on a ground lug right next to the install. Easy, just remember to take the screw out of the center scuff shield to pull the end of the side cover off. And I wiped the wheel well clean to stick the box there, and brought the wires out UNDER the plastic to keep them coiled up under the tire support until needed.
Decent Quality product, however it didn't come with all the necessary parts needed for install. It provided two butt connecters rather than an eyelet connector for the battery. All and all it does its job.
I have a 1999 Jeep Cherokee Sport. The wiring connector at the rear of the Jeep has a 10 pin connector, is this a 10 pin? I also pull off the side cover behind the spare tire, the connector there is also a 10 pin.
Asked by Bob from Spring City, Pa on
Bob, the Tow Ready Wiring T-One Connector is a direct plug and play for your Jeep. I hope this helps!
Answered by Sara H. Ext 4874 from Spring City, Pa on
how difficult is the plug to attach ??? do I need to drop the fuel tank to get to the plugs???? 2003 wrangler x, tj thank you gary
Asked by Gary from Lake Worth , Fl... on
Hi Gary The Wiring T-One Connector is not hard to do but you will have to drill a 3/32 hole and will also need a Phillips head screw driver. You will not need to drop the tank. Thanks
Answered by LWiff ext 4804 from Lake Worth , Fl... on