JK Cowl Induction Hoods with side vents Our cowl induction hood is not only stylish but fully functional. Made from a special blend of high impact polycarbonate plastic and is extremely durable. The material is formed at very high temperatures. 300 plus degrees. The hood is a clamshell design with a full internal structure. The same material is used on commercial buses and is also used on over the road commercial trucks. The hood is designed to direct in outside ambient temp air from the rear of the cowl through a sealed internal duct system and delivers the cooler air to the air box. The side vents exhaust the under hood heat that builds up toward the rear of the engine compartment. This is the most efficient location for the vents. When the vehicle is being driven the air passing by the vents and helps pull the hot air from the engine compartment by creating a vacuum. We also designed the hood to be functional and not let water or debris get into the engine compartment. Due to the nature of the material that the hood is made from paint bonds to the plastic better than metal or fiberglass.
If I want to use an airaid intake will it work out of the box or will I have to modify this hood ?
Asked by Foot from Youngstown, ohio on
Hello, That air intake setup will work fine with this hood without modification. If you have anymore questions feel free to ask, Thank you.
Answered by JordanC extension4833 from Youngstown, ohio on
I have a 07 2dr. JK. what is this hood made from steel or fiberglass or other?
Asked by bram from youngstown, ohio on
Bram, the Truck Master Designs Fully Functional JK Cowl Induction Hood is made out of fiberglass. If you have any other questions, please give me a call. Thanks!
Answered by Sara H. EXT 874 from youngstown, ohio on
is there any cutting or repositioning of parts in the engine compartment on the 2013 2 doors?
Asked by ROCK from FAIR OAKS, PA on
Hello, the Truck Master Designs Fully Functional JK Cowl Induction Hood will need painted to match the exterior color of your Jeep. The hood fits on with the stock factory hinges and latch hardware. You will have to drill the hood for the latch and hood rod to mount on. The top of the factory air box will need to be cut and trimmed for the air induction on the hood to function properly. That's all there is and your ready to enjoy your new Truck Master cowl induction hood. Thank you!
Answered by Bob H from FAIR OAKS, PA on