Built ground up for Ultra4 rock racers, the Spidertrax Ultimate Unit Bearing is truly the reinvention of the unit bearing itself. Genuine Timken bearings, full Chromoly heat treated construction, left & right hand threaded spindle nuts, and a fully integrated drive slug makes the Ultimate Unit Bearing the only racing unit bearing of its kind. The Ultimate Unit Bearing, the last bearing you'll ever need. This Ultimate Unit Bearing uses 5/8"-18 studs on a 5 on 5-1/2" bolt circle, designed specifically for Spidertrax 35 splined axle shafts. It also has a left hand threaded spindle nut, intended for use on the left side of your vehicle (USA driver side).
Spidertrax was founded in 1999 by two New Jersey guys who met each other in vocational school and who both were really into off-roading. Thomas Kingston is an mechanical engineer and Eddie Casanueva is a manufacturing engineer. Their engineering backgrounds combined with their love of off-roading is the key to Spidertrax innovative products. Eddie and Thomas custom produce mods for their own Jeeps. Then they run those mods up and down rock crawling trails until the mods fail. Then they meticulously examine the exact cause of the failure. They then incorporate a solution to the failure into the product design before starting mass production. The Jeep way of build-break-repeat is the very process that brings the quality to Spidertrax products. Shop Spidertrax Offroad Now