Smittybilts fender flares are produced for you in a textured UV stable ABS plastic. This ABS plastic is strong enough for the trail and looks good enough for the city streets. Its durable construction allows it to be flexible without cracking. Bolt it on or paint it first to match your Jeeps paint job. Minimal drilling may be needed for proper installation.
Installed rear fender only so far - used fender washers on o/s to reinforce the plastic cap nut that is to keep the fender from tearing off body. The washers bend nicely with groove shape and painted black blends in fine. The bad - some of the OEM bolts are pressure fit and you have to pop them out. Next, the front bolt is accessible by a 2 " drain hole for the nut. I used dbl side tape to hold the nut to finger tip, but tough to match up as fender holes not aligned to flare. You should start front to back. Next, 2nd hole back used a stainless steel screw as existing hole was too small. Definitely resist tightening bolts until all aligned. otherwise, was easy install under an hour R&R time.
I bought these because they were in stock and in my budget and I needed a set of flares to get through inspections. I thought they would be good, but... The screws pull through if you over tighten just a fraction of a hair. The holes don't exactly line up to the holes in the body and the holes in the platic elongate easily. The plastic caps snap on well, but the bolt will easily pull through if you tighten just a SHADE too much. I don't anticipate this set holding together long. It should get me through inspections and down the road a bit, then I will buy the ones I want later. I hate buying twice.
Look great on my TJ and look awesome when painted to match top. front fenders go on very easy but rear ones are harder to install. When you install the rear flares they sit lower than stock ones so you can see the outline of the old stock fender flares.
FRONT FIT PRETTY GOOD, I USED LARGER WASHERS, BUT THE REAR SET LOWER THEN THE FACTORY FLARES SO YOU COULD SEE WHERE THE OLD FLARE WAS IN THE PAINT AND DOES NOT MATCH UP TO THE DIAMOND PLATE THAT IS ON THE CORNERS AND LOWER ROCKERS
These fenders were of cheap construction. I had to purchase washers to reinforce the fenders, otherwise the screws and provided washers would pull through the plastic. They are listed as off road use but even with the reinforcement the fenders partially tore off just going through light branches on an unmaintained road in Massachusetts. They are great for highway use and mall crawlers that will never see a trail. Stay away if you wheel off road!!!
BUY BUSHWACKER FLARES MORE MONEY BUT WORTH IT FOUR SURE....
I got the flares with no problem from 4 wheel drive but I waited to long to install them wich burdened me later. when I went to install them they 1st came with these black caps wich defeated my whole purpose of getting pocket flairs. I expected a crome finish like the pics. then I went to install and the front set and they barely fit and torked out of shape. then the back ones wern't even close! couldnt even drill new holes because it exposed existing holes. they where just to small like they where in the dryer to long! And smittybuilt just gave me the run around and told me I wasnt installing them rite and to e-mal pics wich I never heard back from, so im stuck with plastic junk! very disapointed to say the least. I even tried to have my body shop at work install them and they just laughed.
very poor fit on rear would not even use them on a nice clean jeep anybody looking at buying them please dont waste your time and money on smittybilt flares buy bushwacker they fit nice and do last test of time unlike smitty[*]
thought i would save a few dollars and give them a shot. the holes didnt line up, had to trim out for the marker lights, the screws are to little, the cheep plastic screw caps fell off. i have a 6" lift and the least little hill the tires rub. they provide good coverage the the angle design sucks. called smitty built and they said thats not there problem... there agin you get what you pay for. so i orderd bushwacker and solved the issue..
Had these things on for about 6 months and noticed that is started breaking through at the attachment points. I read through these other reviews and was shocked to see that no one else had any issues. 3 of the flares have broken on at least 2 of the attachment points. I emailed Smittybilt and received no response. Needless to say I got a tube of plastic fix from the local hardware store and made my own fix for the flares. I also changed the attachments to include a bigger washer and it seems to hold it onto the vehicle better. Not sure if Bushwhacker is any better, but I am not impressed with the Smittybilt so far.
will this fi an 01 sahara?
Asked by nancy from United States on
Nancy, the Smittybilt TJ Wrangler Fender Flare Set will fit your Jeep just fine. Hope this helps!
Answered by Zach O. ext 4939 from United States on
Can I have the specifications of weight and sizes for the box for shipping informations?
Asked by supermanuel from MALTA on
Hi Supermanuel, This Smittybilt TJ Wrangler Fender Flare Set comes in a box that measures 45" long, 26" wide and it's 9" high. It weighs 18lbs. Thank you for your inquiry.
Answered by Jim G Ext 4806 from MALTA on
Will my factory side marker covers fit in these, or do I need to buy new ones?
Asked by D from Orwell, OH on
Hi D from Orwell, These flairs from Smittybilt are designed to re-use your factory side markers, you won't need to get new ones. Thank you for your inquiry.
Answered by Jim G Ext 4806 from Orwell, OH on
For 60 years Smittybilt has been fabricating aftermarket parts and today their products include Jeep tops, bumpers, lighting, winches and trail gear. Off-roaders count on the company's innovative parts like the original nerf bar side steps to equip their Jeeps for the trail and day-to-day driving. Pairing affordability without compromising quality is the hallmark of Smittybilt and the manufacturer's reputation carries over to products like its Overlander Series of tents, Adventure Boxes and SEMA award-winning magnetic trail skins for Jeeps. Smittybilt offers over 2,000 interior and exterior parts and accessories for 4x4s with multiple capabilities for jeepers of all levels. Shop Smittybilt Now
We Pay Your Sales Tax