Rubicon Express 3.5" Standard Coil Lift Kit - No Shocks - RE7142

i have one of those rare 08 jkux with the rear lockers and sway bar disconnects from the factory. so its a half rubi half x. and issues with those factory push button disconnects working on my jeep or should i be looking at a lift deigned for a rubi?

Asked by 08jeepJK from chicago,il on

Hi 08jeepJK The Rubicon Express 3.5 Inch Standard Coil Lift Kit - No Shocks will work just fine with your sway bar disconnects. When you put the lift on leave your sway bar diconnects on and put this lift on. If you have any other quesitons feel free to ask. Thanks,

Answered by roy p ext 4928 from chicago,il on

IN A 2008 JEEP WRANGLER WILL YOU NEED TO BUY A NEW DRIVE SHAFT TO RUN THIS LIFT? ON THE RUBICON EXPRESS WEBSITE IT IMPLYS THAT YOU DO. THANKS!!

Asked by lucas from on

Hello, It is recommended to run the drive shaft so you avoid a drive line vibration. I would definitely run the shaft when the lift is installed. If you have anymore questions feel free to ask, Thank you.

Answered by JordanC extension4833 from on

I have a 2008 jeep wrangler unlimited Sahara and was wondering if this lift will level out the jeep,or does it just lift the front and back the same leaving the front end down a bit like from the factory i am hoping to get the fox racing shocks for it if that makes any difference thanks lucas!!

Asked by Lucas from on

Hi Lucas, Yes, this Rubicon Express 3.5" kit will enable the Jeep to sit a little more level than how the vehicle came new, however it is still slightly higher in the rear. Fox shocks will work great with this lift kit, thanks for the inquiry!

Answered by Jim G from on