This product is 100% garbage. They will not work without resistors, correction, they do not work with resistors. I have built my jeep, bumpers, lift, electrical, fenders, winch, spod, led headlights, tail lights, lights all over it, custom fabrication. I have used 3 different types of resistors with this kit, tried multiple instal techniques. This product does not work, and I cannot tell you more emphatically to NOT BUY THESE. I wish I hadn't. Next stop. Dumpster.
Bought side markers, turn signals and tail lights from RECON, cheaply made, with zero instructions, many parts broke with weeks of installation and tail lights fog up. Poor customer service. Would not recommend to anyone!
Install wasn't too bad...no directions however Recon website had a POC who was very helpful. Overall, I gave it 2 stars as price didn't match product & performance.
Directions? None. If I wanted to rewire a canbus jeep, then this would be a good product. The product fit in the hole in the grill, that was good. Everything else did not meet my expectations.
Is the load resistor built in to these turn signal LED's? .... To prevent the rapid flash?
Asked by Kim from United States on
Hello, the Recon LED Front Turn Signal Lens do not have the load resistors built in. You have to wire in the resistors to the light and wiring harness. Thank you!
Answered by Bob H from United States on