Recons clear and smoked lenses replace the factory amber lenses that are installed as original equipment on Jeep Wranglers. Recons clear and smoked lenses function as amber LED running/parking lights and amber LED turn signals. Each kit includes 2 LED lenses (1 per side). Recons clear and smoked LED lenses are a replacement for the factory installed amber lenses that come as standard equipment on your Jeep Wrangler. Recons clear and smoked lenses with amber LEDs take just minutes to install and add that tough no-nonsense look to your 07-09 Jeep Wrangler. Recons clear and smoked lenses are made to exacting standards which exceed O.E.M. specifications. Recons clear and smoked LED kits are street legal and have been approved for use by the National Highway Traffic Safety Administration (NHSTA). Each Recon clear and smoked LED lens kit comes complete with either clear or smoked lenses and uses super-bright amber colored LED lights for running/parking light & turn signal illumination.
This product is 100% garbage. They will not work without resistors, correction, they do not work with resistors. I have built my jeep, bumpers, lift, electrical, fenders, winch, spod, led headlights, tail lights, lights all over it, custom fabrication. I have used 3 different types of resistors with this kit, tried multiple instal techniques. This product does not work, and I cannot tell you more emphatically to NOT BUY THESE. I wish I hadn't. Next stop. Dumpster.
Bought side markers, turn signals and tail lights from RECON, cheaply made, with zero instructions, many parts broke with weeks of installation and tail lights fog up. Poor customer service. Would not recommend to anyone!
Install wasn't too bad...no directions however Recon website had a POC who was very helpful. Overall, I gave it 2 stars as price didn't match product & performance.
Directions? None. If I wanted to rewire a canbus jeep, then this would be a good product. The product fit in the hole in the grill, that was good. Everything else did not meet my expectations.
Is the load resistor built in to these turn signal LED's? .... To prevent the rapid flash?
Asked by Kim from United States on
Hello, the Recon LED Front Turn Signal Lens do not have the load resistors built in. You have to wire in the resistors to the light and wiring harness. Thank you!
Answered by Bob H from United States on