FREE SHIPPING on Orders over $50*

Prothane Tie Rod Boot Kit - 19-1712

universal fit logo


  • Prothane | Part Number: D/I19-1712
  • Fitment:Universal Fit


At last, it is now possible to replace a dust boot without buying a new tie rod. These boots resist damage from rocks, sand, water and oils. Each has a unique 5-point sealing action that prevents loss of lubricants and contamination. 2 per package as needed.


Not the best fit on my CJ-7

This concerns the Prothane tie-rod end boot kit for the CJ-7(part #D/I19-1712). These are made of thick, sturdy polyurethane in the usual red-orange color. They fit tightly over the shaft, but the lip, or skirt, is not as tight as I would expect, and is too long so it butts up against the tie rod part. This causes the edge of the boot to deform and pushes the whole boot to the side and it sits off-center. Perhaps I wound up with the wrong part, but the website pulled up this part for the CJ-7 and didn't show any other alternative, so that's what I got. Or, this may be the way it's supposed to work, but it looks sloppy. I would recommend, but with a caveat as to the fit.

from Memphis, TN |

Question & Answers

2 Answered questions

Will this boot fit the drag link ball joint at the Pitman arm?

Asked by Rob from Vail, AZ on

Hey Rob, the Prothane Motion Control Tie Rod Boot Kit will work on that tie rod end. Thanks for your question.

Answered by Devin B. ext 4835 from Vail, AZ on

Will this work with an '03 rubicon? One of your pages says it does, another page says that it does not.

Asked by Josh K from on

Hello Josh! Yes, these Motion control tie rod boots will work on your Rubicon. Thank you!

Answered by Bob H from on