FREE SHIPPING on Orders Over $50*

Pro Comp Jeep Crawler Rear Bumper with D-ring Mounts and Receiver (Black) - 66168


  • Pro Comp Suspension | Part Number: EXP66168
  • Finish:Powder Coat
  • Receiver Hitch:Receiver Hitch Yes
  • D-Ring Mount Included:D-Ring Mount Is Included
  • Position:Rear
  • Fitment:Direct Fit
  • Tire Carrier:Tire Carrier No


Constructed with 1/4 inch plate steel, these bumpers are designed for high departure and approach angles. The 1/4 inch inch plate steel helps slide your Jeep over boulders, rocks and stumps. Gloss black powder Coat finish. Drilling Required on 1997-00 TJ Wrangler. 2" receiver is not rated for towing.




Great fit.

This bumper looks great, built strong, and fits the vehicle well. The 4 bolts and two reinforcing plates that go to the inside frame of the Jeep are a BEAR to access. Small hands would be a plus here.

from Ferndale, Wa. |
very nice

mounts very close to tub. I used stock bolts on lower mounts Looks great on my 2006 Golden eagle. As far as install went I did it in 30 mins. I used my 1 ton jack to get the bumper in place.

from Marion il |
Great bumper 4wd never disapoints

Luv this bumper

from IL |
Great Bumper

Great for the price. good quality,and was pretty simple to install. you will have to drill 4 holes if you have an 06 Unlimited.

from Texas |
To much flex in the 2 Receiver

The bumper 2" receiver flex to much with a bike rack in it, Didn't fill safe.

from Thousand Oaks |
Great bumper for the price

For the price, this bumper cannot be beat! A little tough to install by yourself. 10 bolts hold it in place. I would have no fear pulling on it hard or towing with the reciever

from Rochester NY |

Question & Answers

6 Answered questions

What are the dimensions? width length depth?

Asked by xx from denver, co on

Hi xx, This Pro Comp Suspension Jeep Crawler Rear Bumper with D-ring Mounts and Receiver in Black Powder Coat does not have specs from the manufacturer, however it a full width model, not a short/stubby style and is approximately 54". It weighs 50 lbs, great question and thanks for your inquiry.

Answered by Jim G Ext 4806 from denver, co on

I have a 97 TJ Sport with after market tow hitch. Will I be able to install this bumper with my existing tow hitch already installed?

Asked by walter from sc on

Hello, You will have to remove the factory hitch in order to run this bumpers setup. If you have anymore questions feel free to ask, Thank you.

Answered by JordanC extension4833 from sc on

Will this fit with another receiver?

Asked by jacob from sc on

Jacob, the Pro Comp Suspension Jeep Crawler Rear Bumper with D-rings and Reciever in Black Powder Coat will fit most receivers on the market! I hope this helps!

Answered by Sara H. Ext 4874 from sc on

See all questions & answers


Pro Comp Suspension has spent the last two-and-a-half decades engineering, testing and manufacturing products that will give Jeep drivers the confidence to dominate whatever terrain is ahead. The Pro Comp Promise Life Time Warranty is forever. Pro Comp's warranty goes with the suspension products on Jeeps whether or not the Jeep owner is the person who originally purchased the product. Pro Comp Suspension can afford to give such a warranty because the products are produced at the Pro Comp facility in San Diego, California under exacting manufacturing standards. Pro Comp Suspension is the only suspension company with products that are tested under true driving conditions on outside roads, rather than simulated testing. Shop Pro Comp Suspension Now