Pro Comps rear CV replacement driveshaft's are designed to be used with Pro Comp slip yoke eliminator kits. They're 2-piece style driveshaft's made of high-quality steel.
i have a 4 inch lift on my 1988 yj stock drive shaft is short would this product fit my jeep?
Asked by hubby from long island n.y. on
Hi Hubby Yes you could use the CV-Style Drive Shaft but you will also need to install a slip yoke eliminator to shorten the transfer case.
Answered by LWiff ext 4804 from long island n.y. on
I bought this shaft a few years ago and need to replace the rear u joint by the rear end and was wondering what is the specifications of it.
Asked by part by part from ny on
This ProComp Suspension CV-Style Drive Shaft uses a 1310 U-Joint. You can find our selection of 1310 U-Joints here: [http://jo.my/1310_u-joints] Thanks!
Answered by Craig R. from ny on
Pro Comp Suspension has spent the last two-and-a-half decades engineering, testing and manufacturing products that will give Jeep drivers the confidence to dominate whatever terrain is ahead. The Pro Comp Promise Life Time Warranty is forever. Pro Comp's warranty goes with the suspension products on Jeeps whether or not the Jeep owner is the person who originally purchased the product. Pro Comp Suspension can afford to give such a warranty because the products are produced at the Pro Comp facility in San Diego, California under exacting manufacturing standards. Pro Comp Suspension is the only suspension company with products that are tested under true driving conditions on outside roads, rather than simulated testing. Shop Pro Comp Suspension Now