We Pay Your Sales Tax + FREE SHIPPING on Orders Over $50*

 Power Trax Dana 30 27 Spline Lock Right Locker - 2210-LR

Part Number: PTX2210-LR

Specifications

  • Popular Axle Manufacture: Dana
  • product.stock: In Stock
  • Fitment: Universal Fit
  • Axle Spline: 27 Splines
  • product.stock: In Stock
  • Differential Type: Automatic Locker

    TECHNICAL DETAILS

  • For Use With 27 Spline Axles
  • For Open Differential Only
  • Includes Zytanium Cross Shaft
  • No Need To Set Up Gears Reuses Existing Carrier
  • Arrgesive Traction

PRODUCT OVERVIEW

Brute Force Devices For Rugged Applications,Best Value For Greatly Increased Traction,Complete Replacement Of Diff. Case Not Req.,Simple Installation,Ring And Pinion Setup Not Altered,Installs Easily In Front/Rear Or Both,Proven In Most Demanding Applications.

Reviews

4.6
4.6 4.6
4.0
Right Item for the Right Job

A couple of hour job actually turned into a couple of day job...only because of other axle bearings and seals that needed replacing. Highly recommend you go ahead and replace bearings/seals while you have the axles out. The lockers themselves were easy to install in my '82 CJ-5. Put them in the front axle (instead of rear) since the only time I'd use them is in 4wd. Did great in some tough rocky trails. Only 4 stars because I've only put them through one tough test so far. But so far, so good.


from Southern New Mexico |
4.0
Very Nice

I have installed three of these now. Two in my own jeep dana 30 front dana 35 rear. This 2004 wrangler will go anywhere now. My jeep had the thin ring gear. Locker was installed inside the diff without removing the carrier. My brothers jeep same 2004 dana had a thick ring gear I had to remove the carrier and install the locker on a work bench. Still installed in about 1HR. Note you can remove the carrier without moving the pinion there for no set up is required just re tork the carrier. I also noticed that a tube of Differential Friction Modifier helped on the harsh releases. I used Equa-Torque. from Sta-lube. great stuff.


from Mansfield CT. |
5.0
Works Great!

My cherokee is purely for offroading and installing this lockright in my front end has made a world of difference. I would highly recommend.I have no problems steering on road. The instructions are little vague and the pictures of our little blotchy, but after watching a few YouTube videos from others on how to install it, it worked out just fine. I would highly recommend this locker.


from Phoenix, AZ |

Question & Answers

15 Answered questions

hi I was wondering if this part will work on a 1997 jeep Cherokee 2door sport with a stock Dana 30 on it if so please let me know thank you

Asked by mudder from on

Hi Mudder The Dana 30 Lock Right Locker will work on your Jeep but it will effect the steering and if driving on the road will want to do the steering and make it a chore to drive as it is always locked up when accelerating. Thanks

Answered by LWiff ext 4804 from on

I have 2015 JKU I am planning on doing a gear swap to the G2 set up G/24-JK-456 will this locker work with this set up. Also will I need to purchase anything else with the gear set? (Carrier?)

Asked by daddychas from Clark,NJ on

Hello, The Power Trax Dana 30 27 Spline Lock Right Locker will work for your open carrier. If you have 3:73 gears in your JK then a carrier will not be needed. If your gear ratio is numerically lower you will need a different open carrier. I will put a link below for the one you may need. Please let us know if you have any other questions. Thanks! http://www.4wd.com/Drivetrain-Differential/Open-Differential-Case.aspx?t_c=12&t_s=237&t_pt=5589&t_pn=D/S2010999

Answered by Tom S. Ext. 4876 from Clark,NJ on

will this fit my 2004 jeep wrangler with the front dana 30

Asked by mikey from on

Mikey, the Power Trax Dana 30 27 Spline Lock Right Locker will work with your Jeep as long as you have 27 spline axles. I hope this helps!

Answered by Sara H. Ext 4874 from on

See all questions & answers

Promotions

We Pay Your Sales Tax! Limited Time Only!