Securely add a seatbelt mount point to your cage with these machined steel seatbelt bungs. Simply cross-drill a hole through the cage tube and weld the bung in. The internally threaded end accepts common seatbelt mounting hardware. Sized to work with 1.75" OD tubing. These are most commonly used for the shoulder belt mount point but can also be used for aftermarket lap belts. They may also be used for mounting hi-lift jacks and other equipment to the cage, bumpers, etc. Sold individually (if you need a pair of them, order two).
How big of a hole needs to be drilled in the roll cage for these to fit?
Asked by Darryl from Torrance on
Darryl, the Poison Spyder Customs Machined Seatbelt Bung needs a 1/2" hole to slide into. Hope this helps!
Answered by Zach O. ext 4939 from Torrance on
Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now