The Poison Spyder JK License Plate Mount allows you to relocate your Jeep's license plate to the center of the tailgate, for those who run without a tailgate-mounted spare tire. The License Plate Mount uses four of the OE spare tire mount bolts, and is offset to allow proper function of the tailgate vents. If using this item to relocate the license plate, we recommend using the Stock License Plate Delete Cover # PSC17-04-112 to fill the hole where the factory license plate mount was located. NOTE: This item was designed to fit JK's with the wide vent on the tailgate (vent is wider than it is tall). These are generally found on 2010 and newer JK's, however they have also been found on some 2009's. This item may also be used on JK's with the tall tailgate vent (taller than it is wide), which were typically found on 2007-2009 JK's, however the edges of the vent may still be visible above and below the license plate.
Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now