The Poison Spyder Customs BFH II rear bumper is designed for those hardcore four-wheelers who value strength, simplicity and function. This bumper was literally "Built For the Hammers" designed with light weight, toughness and performance in mind. It is basically a "frame cap" style bumper, hugging the rear end of the Jeeps frame and cross member to provide the best obstacle clearance and departure angle possible. But unlike other frame cap bumpers that are on the market, the BFH II incorporates signature Poison Spyder style, with multiple angles and facets to give the bumper great looks on top of its hard core functionality. The BFH II is CNC laser-cut from high strength 3/16" plate steel, then precision brake-formed for an exact fit over the Jeeps rear frame and cross member. The heavy duty recovery shackles are CNC machined from 1" thick plate steel, and welded both inside and outside the bumper shell. The tabs are standard equipment on the BFH II, and are designed to accept 3/4" recovery shackles (AKA "D-Rings"). This bumper is available in bare steel only, it will need to be painted or powder coated prior to final installation. The BFH II Rear Bumper is easily installed using captured grade-8 hardware and the Jeeps existing bumper mounting holes. This bumper is intended for those hard-core wheelers who either wheel without a spare or strap the spare down into the bed of the Jeep. Poison Spyder Customs BFH front bumper is designed for those hardcore four-wheelers who value strength, simplicity and function. This bumper was literally "Built For the Hammers" with the best ground clearance, tire clearance and approach angle possible. It is no wider than the Jeeps frame rails, with angled facets to improve its ability to slide over the rocks. The BFH bumper is CNC laser-cut from a single piece of high strength 3/16" plate steel, then precision brake-formed for an exact fit. The BFH bumper features an integrated winch mount and one-piece design. The Brawler Bar is a lower-profile Stinger, fashioned after the 2-bend Stinger featured on our Original RockBrawler bumper for JK. The Brawler Bar features the most versatile combination of trail protection and a lower profile for easier access to the engine compartment, fitment into garages and trailers, etc. Plus it looks bad-ass! The Brawler Bar extends 7.4" forward from the front edge of the bumper, and 9.8" high from the top surface of the bumper. The Recovery Shackle Tabs are machined from 1" thick plate steel to provide a secure attachment point for 3/4" recovery shackles. These tabs are specifically engineered to match the angles of the BFH bumper to result in zero loss in approach angle.
Manufacturing products exclusively for Jeeps, Genuine Packages carries front bumpers, suspension systems, LED light bars, receiver hitches and more. Upgrade your Jeep's bumpers with front and rear ones from Genuine Packages that are compatible with 2 and 4-door models. When you're looking for part replacements to get trail-ready for anything you encounter, products from Genuine Packages fit the bill. We carry a full lineup of interior and exterior items. Forget overpriced parts and accessories for Jeeps and go with products produced by Genuine Packages. Shop Genuine Packages Now