A DEFFINATE IMPROVEMENT OVER STOCK JEEP AXLES. The stock axles I had spun loose at the flange, I cant imagine with this design that it will ever happen again
Everything was there to swap out the axles. Don't try to press on the bearing and the sleeve at the same time, just too much force needed. Doing each alone it worked fine. Slipped right on and matched the length. Used the same shims from my original axles and everything lined up.
Will this product fit a Jeep 1985 CJ-7, 4.2L 6 cyl, manual transmission?
Asked by Jimmy from Guanica, PR on
Jimmy, the Moser Engineering AMC Model 20 CJ Wide Trac One-Piece Axle Kit is made for Jeep CJ's with the Widetrac AMC 20 rear axle. So, as long as your Jeep has that axle, which judging by the year it should. Then you'll be just fine with this kit. Hope this helps!
Answered by Zach O. ext 4939 from Guanica, PR on
I have a 1986 CJ7 will the thrust block need to be removed with this kit?
Asked by JR from Cookeville TN on
Hi JR Yes it should be removed to let the axles go in as needed on the AMC Model 20 CJ Wide Trac One-Piece Axle Kit. Thanks
Answered by LWiff ext 4804 from Cookeville TN on
this kit will only fit with 1976-79 cj7 with factory T-400 automatic transmission and Quadra-Trac transfer case?
Asked by joseph mercieca from malta on
Hello Joseph, Yes the Moser Engineering AMC Model 20 CJ Quadratrac One-Piece Axle Kit will only fit quadratrac axles. However i do offer them for narrow track and wide track axles as well. Thanks for the inquiry.
Answered by Adam from malta on