Qualifies for Free Shipping on Orders Over $50
Hello 2 ALL at 4WD Which wire do I connect these load EQ's too please? I would think that they would get wired into the red wire but I am not sure.
Asked by Ray from Wasilla Alaska on
Ray, the In Pro Carwear Load Equalizer for LED Lights wire into the power and then the ground. Hope this helps!
Answered by Zach O. ext 4939 from Wasilla Alaska on
Where do you install the Load Equalizer for LED lights on a 85' CJ7?
Asked by Tom from Temecula,CA on
Hello, these In Pro Carwear Load Equalizer for LED Lights get installed when you are putting in the lights you wire them in the harness wiring for each LED light installed. Thank you!
Answered by Bob H from Temecula,CA on
Pro Car Wear, Inc is an off-road lighting company based in Commerce, California and all of the lights the company produces are FMVSS-108/DOT/SAE compliant. Pro Car Wear prides itself on its exacting manufacturing techniques, which produce better fitting lights, lights with more attractive finishes and ones with better gasket seals. All the manufacturing of Pro Car Wear, Inc products takes place at their facility in Commerce, CA. The tenet upon which Pro Car Wear, Inc prides itself the most is the manner in which installation of their lights makes a Jeep look stunning and how well the lights fit on the vehicle's exterior. Shop In Pro Carwear Now