Save Up To $500 On Jeep Parts & Accessories | Click here
These hard to find Bolt And Strap kits are available for most common driveshaft U-Joint sizes are available from Dana Spicer will give you the piece of mind that your expensive driveshaft is correctly held in place. These kits are made with stamped steel straps and supplied with grade 8 retaining bolts.
I have the Chrysler 8.25 axle on my XJ. Will these straps work for that?
Asked by Juarez from on
Juarez, the Dana Spicer 1310 U-Joint Strap Kit is made for any 1310 series u-bolt yoke. As long as you have the u-bolt yoke the you'll be good to go!
Answered by Zach O. ext 4939 from on
I have a 97 jeep wrangler TJ will these work for both ends of the front driveshaft?
Asked by Rod from Virginia on
Rod, the Dana Spicer 1310 U-Joint Strap Kit will work for both ends of the driveshaft. I hope this helps.
Answered by Sara H. Ext 4874 from Virginia on
Hello, I have a 92 YJ and need the straps for both ends of my front drive shaft are this the correct unit for the front and I would also like the part number for the rear. Thank you, Justin
Asked by Justin from Eau Claire, WI on
Hello, this Dana Spicer U-Joint Strap KIt will work for the front or rear drive shafts. They are all the same. Thank you!
Answered by Bob H from Eau Claire, WI on
Dana Spicer products strive to meet the same high standards as OE parts, but in reality they are OE parts. The company's commitment to engineering and design innovation stretches back to 1904 when Dana was founded and began producing Spicer products. That legacy translates to quality, dependable axle components that keep Jeeps out on the trail and help daily drivers brave commutes with confidence. Driveshaft parts, universal joints, Dana axles and Spicer axle components are some of the Dana Spicer products that Jeep owners know they can count on. When you need to tighten up a sloppy differential, replace the clutches in your limited slip or replace a worn out yoke, call on Dana Spicer. Shop Dana Spicer Now