Replacement gauge that reads 5-85 mph and fits into stock location on 4 studs. Gauge has 6 bulb locations for cluster and comes with fuel and temperature gauge. In tank fuel sending unit may have to be calibrated for the fuel gauge to work properly.
Is it possible to reset the odometer to match the miles shown on the unit I'm replacing? (Can I set it to 170,000 miles before I install it?) My Jeep is a 1985 CJ7 with stock sending units. I plan to also replace the cable.
Asked by Phil from Lyons, Colorado on
Phil, Due to differing laws about the odometer you will have to check your local laws to find out if you can. Please let us know if you have any other questions. Thanks!
Answered by Tom S. Ext. 4876 from Lyons, Colorado on
what is the ohms at full & empty reading for the fuel gauge? What temperature sender part # matches the temp gauge?
Asked by JtK19541990 from on
Hello! For this fuel gauge you will see the following readings: With an empty tank: 73 ohms With a full tank: 10 ohms Your stock/OEM sender should work, but if you don't have that one, try this Crown Automotive part : http://jo.my/cj_temp_sender http://jo.my/cj_temp_sender
Answered by Aaron S. from on
were does the water temp. wire connect to speedometer assembly
Asked by john from whitehouse tx. on
John there are connections on the back of this Crown Automotive Replacement Speedometer Assembly for the water and fuel gauge.
Answered by Jason L from whitehouse tx. on
With this mission Crown Automotive has been in business for over five decades, delivering original-quality replacement parts at fair aftermarket prices. Crown Automotive has individual parts for sale as well as complete Crown Jeep kits for everything from axle to electrical to transfer case to wiper kits. In recent decades, Crown Automotive has expanded to producing replacement parts for Chrysler and Dodge vehicles as well. Shop Crown Automotive Now
Save 10% On Crown