Up To $500 Off Tires and Wheels | Shop Now
Banks TorqueTube is a streamlined exhaust manifold designed to optimize exhaust flow and engine efficiency. Because the stock manifolds flange does not align squarely with the ports, flow is restricted. TorqueTube corrects the problem with a half-inch flange that is machined dead flat, and precisely fitted to the port pattern. You can hear the difference in the plusher, healthier exhaust note. Unlike the stock, failure-prone exhaust manifold, Banks TorqueTube is built of heavy, 409 stainless steel to weather a lifetime of heat, stress and abuse. The flange, welded to the tube assembly on both sides, will never crack or separate. The gasket is made of SMI 900, a material that stands up to super-hot temperatures. Bolts right on!
Installed the Banks Cold Air Intake about 4 months ago. I saw a slight improvement in MPG but needed to improve throttle response, so this week I installed the Banks Torque Tubes and Banks Monster exhaust. Installation time was roughly 4 hours with a bit of knuckle busting, about what I expected. The exhaust note is noticeably deeper and sounds good going up through the RPM's. Using my "seat of the pants" Dyno testing, the HP and torque are noticeably better especially on acceleration and I'm downshifting less often on hills. Next I intend to get the Autominder Programmer to be able to adjust the performance for off-road or highway requirements
My TJ has the 4.0L/automatic, are there any fitment issues because its an automatic?
Asked by Rocker from Corpus Christi, Tx on
There shouldn't be any fitment issues because you have an automatic transmission. The factory exhaust is the same for both manual and automatic.
Answered by Aaron S. from Corpus Christi, Tx on
This says its for a 1997-2002 jeep wrangler but when I put my info in about my jeep it says it does not fit my 2002 wrangler
Asked by Andy from laurel on
Hello, this Banks Power Torque Tube Exhaust Header will fit your 2002 TJ Wrangler with the 4.0L 6 cylinder engine. It's a direct replacement for the stock manifold. Thank you!
Answered by Bob H from laurel on
Asked by from National city, CA on
This is CARB Approved and includes the CARB EO sticker for inspections.
Answered by Jamey from National city, CA on
Headquartered in Azusa, California, Banks Power was a byproduct of Banks Engineering, established over 50 years ago. Its decorated history of breakthrough innovations in gas and diesel engine advancements includes drivetrain and turbocharging and high performance products for gas and diesel systems. Among its Jeep products are sidewinder turbos, exhaust manifolds, tuners and programmers and cold air intakes. Whether you're turbocharging, trying to boost exhaust flow and reduce backpressure or optimizing engine efficiency, Banks Power's impressive lineup of parts and accessories are durable enough to weather the stress and perform under extreme duress. Shop Banks Power Now