This heavy duty truss and bracket system is designed to take serious abuse and reinforce your entire axle while also providing the factory link, anti-sway bar, and shock locations. The 1/4" thick truss top incorporates a unique design to strengthen both the axle and incorporate the link brackets for ease of installation and added strength. By incorporating the link mounts into the truss, hours of work and trial and error can be avoided when compared to other bracket systems. Simply tack weld the truss together, place it on the axle and all the other brackets fit into place exactly where they need to be. The Ford Explorer 8.8 features: same lug nut bolt pattern as Dana 35, 3-1/4" diameter tubes as compared to 2.625" Dana 35, disc brakes (1995 & newer), 31 spline axle shafts, 8.8" diameter ring gear which 120% stronger than Dana 35, only 20 pounds more than Dana 35, and a trac-loc differential stock. When swapping, the 3.73 gear ratio may need to be changed to match your Jeep gears and wheel spacers may be necessary to bring the width back to factory specs since the 8.8 is 1.25" narrower than the Dana 35. Please note this requires welding and general fabrication. Some grinding and fitment may be required when installing this kit. Every axle varies slightly and some fabrication may be required. Will require brake line relocation to fit.
The fit is very good and well thought out
Instructions work but could be better
This kit is well worth the money. Very easy to install. Instruction were easy to follow. The only thing i found was different from the instructions was the angle for the shock mounts. I ended up cutting them off and re-welding them to a different angle. Nothing major,but I would recommend welding them on last after you have installed the axle back under the jeep.
Artec Industries is based in Salt Lake City, Utah, but its origins are an American success story based in Tucscon, Arizona. The owner, Artie Nuttall, married into a family of off-roaders who quickly infected him with their enthusiasm. So much so that Nuttall took a welding class at a community college so that he could complete DIY axle swaps on his rig in his garage. Turns out he had a talent for welding and in 2010 Artie successfully marketed a line of battery mounts. From there, Artec Welding turned into Artec Industries and though the product line and success grew, Nuttall's attention to craftsmanship and quality never wavered. Shop Artec Industries Now