Up To 20% Off While Supplies Last | Shop Now
The Front 60 that works with this kit is from Ford Superduty F-250 and F-350 trucks from model years '99-04' (leaf spring) and 05+ (coil spring). This truss is not intended for older axles due to different differential offsets. Please ensure it is a 60 because these model years also had Dana 50 available. The casting or ID tag should say either 248 ('99-'04) or 256 ('05+). Extensive trimming of the factory differential casting will be necessary (see instructions). Other fabrication and modifications may be needed due to variances in lift kits and other factors. Minimum of 4 inch lift required to run this kit with likely modifications. 5+ inches recommended. This will require bumpstop extensions and a new trackbar since the steering is different on this axle from factory axle. The trackbar bracket is higher than stock location to allow proper steering geometry.
Artec Industries is based in Salt Lake City, Utah, but its origins are an American success story based in Tucscon, Arizona. The owner, Artie Nuttall, married into a family of off-roaders who quickly infected him with their enthusiasm. So much so that Nuttall took a welding class at a community college so that he could complete DIY axle swaps on his rig in his garage. Turns out he had a talent for welding and in 2010 Artie successfully marketed a line of battery mounts. From there, Artec Welding turned into Artec Industries and though the product line and success grew, Nuttall's attention to craftsmanship and quality never wavered. Shop Artec Industries Now
Lowest Price! Guaranteed!