Protect your fog light lenses and get that off-road look with this stylish pair of textured black fog light euro guards from Rugged Ridge that is designed to last! No drilling required for installation.
Instructions suggest to remove the plastic underbelly to access the fog lights. Remove 4 screws from each fog light ( the driver's side is extremely difficult to get to the 2 outside screws due to obstructions in the way). Once the fog light is removed, place the euro guard in to the opening, replace the fog light and install 4 screws. Pretty simple right? However, after over an hour of trying to get the fog lights back in, I realized that if you have a special model JK with a colored bumper cover over the center section (Altitude, or in my case a Black Bear Edition) they will not fit without removing the center cover first. I removed the center bumper cover, and then the fog lights fit back into place with the guards over them. I re-installed the fogs then had to re-install the center bumper cover. My advice, install the center bumper cover by first putting in the 4 screws underneath finger-tight, then really stretch it over the top so that you can get the remaining 4 screws in. Tighten everything back up and you'll be good to go.
Will these fog light guards fit a 2016 Unlimited Back Country Edition with the stock AEV steel bumper?
Asked by JM from Plano, TX on
Hi JM the Rugged Ridge Fog Light Euro Guards are only for the stock factory bumpers and will not work with your bumper. If you have any other questions feel free to ask. Thanks,
Answered by roy ext 4928 from Plano, TX on