Get that offroad look with Rugged Ridge Body Armor! Each Body Armor piece is constructed of black diamond plate looking UV treated thermoplastic for the coolest, toughest looking up-grade for your Jeep. Each body armor attaches to your Jeep with ultra strong 3M tape to ensure a secure fit (front guard also may require some under hood drilling). Have a scratch or dent on your paint? Cover it up with body armor! Simply fill in the scratched area with touch-up paint (to prevent rust) and install the Body Armor. You have now repaired and upgraded!
Great product and looks good but the holes did not line up at all which made it very difficult to install
Supposed to be no drill. Everything included. NOT. Started on left side. Remove lite and licence plate mount. Tried to line up holes, not even close. Line up the gas inlet ok and the tail lite and licence plate holes don't match. Line up the licence plate holes and the tail lite and gas cap holes don't match. OH! and don't forget to mount your plate before attatching the corner. Also you will need to loosen the fender flares, or cut the corner guards. Have a drill and a dremel handy. The hole for the lite plug may need to be enlarged. Needed to drill new holes in the guard to get the screws through. Took me 3 hrs to do the left side.
It's a great looking product.However;on the install I was expecting the left(Driver)side to be the most difficult;I could'nt have been more wrong. On the other side is where I had the most problems due to the GREAT people at Chrysler. The simple fact that they were'nt very generous with the pigtail wiring that causes you to have to remove the right inner wheel well and traverse the evap. canister to access the connector.Other than that it was pretty simple.