Designed to give you a 7" increase in rear drive shaft length that's 3 more inches than our current SYE kit. Constructed of nodular reinforced 356-T6 aluminum for superior strength. Kit is complete with hardware, instructions and speed sensor for an easy bolt on installation. *Note: Uses drive shaft #16592.06.
The new tone ring is not splined and without a shim between it and the yoke, it will spin. This creates a wandering speedometer, especially under acceleration and highway cruise. The shim you need is .075thickness 1.54 ID 2.25 OD. Always use a new pinion nut (same nut as your dana 30/35/44 diff)and red loctite. Its a great kit, but get this shim and install it the first time.
Does this part fit in my Jeep Wrangler Rubicon 2003?
Asked by Leo from Monterey, Ca on
HI Leo the Rugged Ridge NP231 Mega Short Shaft Slip Yoke Eliminator Kit will not work with your rubicon it has a 241 trasfer case. If you have any other questions feel free to ask. Thanks,
Answered by roy ext 4928 from Monterey, Ca on
Will this work with an Oliver rear Drive shaft?
Asked by Casey from on
Casey, as long as your driveshaft is a CV style shaft, then it will work with the Rugged Ridge NP231 Mega Short Shaft Slip Yoke Eliminator Kit. Thanks for the question!
Answered by Sara H. Ext 4874 from on
Does this kit come assembled???
Asked by ray from Conroe tx. on
Ray, The Rugged Ridge NP231 Mega Short Shaft Slip Yoke Eliminator Kit does not come assembled. This must be installed in your factory transfer case. Please let us know if you have any other questions. Thanks!
Answered by Tom S @ Ext 4876 from Conroe tx. on