Rock Hard XJ Cherokee Rear Bumper/Tire-Carriers are made out of 3/16 x 2 x 4 thick tubing in the center and with outer edges that are made of 1/4 plate. This bumper also comes with (2)-5/8 x 2-1/2 CNC D-Ring shackle mount with tabs that are welded on front, go through bumper and then welded on the backside also. A horizontal Hi-Lift Jack mount with padlock provision comes standard as well as a 2 receiver for towing. The swing out tire carrier will hold up to a 38 tire. Easy open latch. Just lift lever to open self-latching design. To close, simply push it shut. Also included is a double safety latch with hard plastic rest and rubber stop for a rattle free operation. Spring loaded auto-locking pin system. Tire carrier locks in the open position so it will not swing back at you. To close, just lift tee handle on the pin and let it swing shut. Also, notice the zerk nipple to allow greasing of the hinge bearings. All needed hardware is furnished for installation.
The concept for Nebraska-based Rock Hard 4x4 Parts was hatched back in the 1980s and evolved from DIY cage installation to a full-service manufacturing facility. Employing state-of-the-art CNC machining centers, outstanding craftsmanship and laser cut precision, Rock Hard takes the bolt-in design of bumpers, skid plates, cages and sliders to the next level. Their patented locking collar distinguishes itself in the aftermarket industry and all of their exterior products make off-roading in Jeeps safer and smoother. Protection is paramount on the trail and Rock Hard's products are easy to install, affordable and exude superior style. Shop Rock Hard 4x4 Parts Now