how do I install this seal? it is a 1994 jeep wrangler yj, it has new windshield and all seal around it are new. I am still getting water coming in behind the dash. the seal at bottom of cowl was not replaced and is in rough shape,so I thjink this is where the water is coming in at.
Asked by normo from east texas on
Normo, in order to install this Omix-Ada Cowl Seal you will have to remove the windshield hinges from inside the cab of the jeep and tilt down the windshield frame. There should be a few screws holding on the current one in place, unscrew and remove the old seal. Then just attach the new seal ( you may want to add a bead of clear silicone). I would also say take the seal out of the package and let it lay flat for a day.
Answered by Jason L from east texas on
does the lip go up or down
Asked by gm from tn on
GM, every time I have installed one of these cowl seals I put the lip up.
Answered by Jason L from tn on
what kind of adhesive is needed
Asked by bob customer# 5800397 from palm beach gardens florida on
Installation of this Omix-Ada Cowl Seal does not require any adhesive or sealant. Thanks!
Answered by Craig R. from palm beach gardens florida on