Measure from the outer edge of the seal on the original transfer case tailhousing to the center of the differential yoke u-joint. This measurement will be the center to center u-joint measurement for the new drive shaft and should be between 19 and 21 long. CV drive shafts are specifically made for NP231 slip yoke eliminator kits. Shafts are made using quality Dana Spicer components. Slip spline is coated to prevent corrosion. drive shaft tube and universal joints include grease fittings and grade 8 attaching bolts are included for CV yoke. Slip spline is 1-3/8 outside diameter and 1-7/8 outside diameter. Don't settle for inferior drive shafts when performing your off-road upgrades. Please follow the measuring procedure to select the correct drive shaft for your vehicle. If your measurement differs from the ones listed, these drive shafts should not be used. This drive shaft uses Spicer 1330 series U-joint at the differential yoke. U-joint is 3-5/8 wide.
Rugged Ridge was established in 2005 by the company Omix-ADA to focus on innovative aftermarket Jeep accessories. Many of Rugged Ridge's recent designs are so innovative they have been patented. This includes their floor liners, snorkel and XHD Modular Bumpers. Since 2005 Rugged Ridge has developed and manufactured over 3,000 kinds of Jeep related products. All Rugged Ridge Jeep accessories are trail rated. The Omix-ADA founder came from a family that owned a small Jeep dealership. It was the founder's dream from a young age to own a company that made accessories for Jeeps. The founder manifested the dream in 1992. Shop Rugged Ridge Now