Brake proportioning valve (1982-86 CJ) for stock brakes only.
PURCHASED THIS VALVE 6-24-13 INSTALLED 7-18-13 STARTED LEAKING BRAKE FLUID 11-25-13 THEY SAID ONLY HAD 30 DAY WARRANTY
The electrical connection on the new unit is a one wrie set-up, meaning that it grounds through it's body into the frame. the set up on my 83 CJ-7 is a two wire set-up. This means the switch wire DOES NOT WORK! The plug (or coupler) does NOT fit! I just left it off, so now, I do NOT have a "Low Hydraulic Pressure Warning Light" No biggy for me, as it is just an old jeep and if the pedal goes to the floor, I will immeadiately know that my brake pressure has been lost, LOL!
I have a 77 cj5 that came stock with drum/drum brakes. I upgraded the complete front axle with a donor 78 Dana 30 that has disc brakes. Will I have to change the proportioning valve to accomodate the front disc brakes or will I be fine just swapping the master cylinder to a disc/drum unit?
Asked by smoke from pa on
Smoke, It is recommended to replace the proportioning valve as the fluid pressure between front and rear is different between drum and disc. Please let us know if you have any other questions. Thanks!
Answered by Tom S @ Ext 4876 from pa on
I understand this will not work in my 81 CJ8? What is it about it that makes it not work? Can I get adapters or differently threaded lines or something?? thank you, Alan
Asked by Alan from NC on
Hello Allen, The Inline Tube Brake Proportioning Valve difference is the brake switch. One is a 2 wire and one is a 1 wire. You can use your existing switch in this proportioning valve and it should work fine on your 81. Hope that helps.
Answered by Adam from NC on
I have a 1981 jeep CJ 7 with a 258 inline engine.what proportion valve will work on my vehicle? any help will be appreciated. dane carpenter
Asked by mad dog from on
Hey Mad Dog, the Inline Tube Brake Proportioning Valve would not work for your and at this time we do not have one that will. Thanks for your question.
Answered by Devin B. ext 4835 from on
Inline Tube started in 1995 and was based in a 2-car garage in Shelby Township, Michigan. Seven years later, Inline Tube upgraded to a 14,000 sq. ft. production facility. Since 2014, the Inline Tube corporate headquarters and production facility has been a 28,000 sq. ft. facility still located in Shelby Township, Michigan. All of Inline Tube's 24,000 plus parts are manufactured at the Shelby Township facility. In addition to tubing for the DIY jeeper who is restoring an old Willy or another classic Jeep, Inline Tube produces parts for exhaust upgrades, brake upgrades and fuel system upgrades. Shop Inline Tube Now