Poison Spyder Ricochet Rockers are built with the same hardcore toughness as its counterpart the Rocker Knocker, with the added utility of a combination 5" step and slider. This rocker protection is the pinnacle of hardcore body armor protection, style and convenience. The Ricochet Rocker protection can be used alone or in combination with Crusher Corners. The two body armor pieces fit together at the rear flare area. Used together, Ricochet Rockers' and Crusher Corners� form the ultimate protection, guarding your Jeep's body from the front wheel well to the tailgate. Ricochet Rockers are secured with counter sunk 3/8" stainless hardware, supplied in the kit with detailed installation instructions. Ricochet Rockers have a distinguishing 5" dimpled plate that acts as a step and a stout reinforcement for the slider. This makes the Ricochet Rocker protection a very effective armor addition and an effective pivot for getting into your rock chariot. With the dimple protrusions pointing upward, they give the extra benefit of increased foot traction when entering or exiting the vehicle, even with boots covered with snow or mud Ricochet Rockers are further reinforced with additional bracing below the dimpled step. The dual tube support and slider bar is constructed of 1.5" DOM tubing, the step and corner gussets are CNC laser cut from 3/16" steel plate, and brake-formed to act as their own gusset for strength and a clean appearance. Everything is professionally welded and comes to you ready to paint and bolt on. For installations in which you would like to protect the paint underneath the Ricochet Rocker, as well as provide a measure of vibration absorption, we offer an optional Rubber Liner, precisely cut to fit between the Rocker Knocker and the Jeep's body. Be sure to order these separately, as they're not included in the standard Ricochet Rocker package.
Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now