Jeep Parts Home » Jeep Performance Electrical » Jeep Chassis Wire Harnesses » Replacement Wiring Harness

Painless Wiring Part 10110 - Replacement Wiring Harness
Scroll Right Scroll Left

Replacement Wiring Harness

By Painless Wiring

Part Number: PWP10110
  • Share
Help us ensure this part fits your vehicle Check Fitment

Overview

Factory Style CJ Replacement Harness Features:
#10110 - For 1975-86 CJ Series Jeeps. Almost every circuit on this harness is pre-terminated at both ends. All wires are color coded and labeled and all wire leads are pre-cut to proper lengths. Our harness uses an OEM style bulkhead connector that attaches to the bulkhead without any special brackets or modifications. The blade type fuse block wiring is factory installed and machine crimped. The most Painless way to wire your 75-86 CJ Series Jeep.

Engine Harness: Chassis ground, brake failure warning switch, horn, windshield washer, heater motor, park and signal lights, front marker light (w/bulb socket), headlights, sending units, starting, charging, ignition circuits, tachometer lead, ballast resistor, maxi fuse, terminal ends, wire ties and grommets.

Rear Harness: Main harness-to-rear harness, rear marker lights (with bulb sockets), rear lamp ground and tail light housing (4 wire).

Main Body Harness: Heavy duty blade style ATO fuse block, heater switch, blower motor resistor, dimmer switch, ignition switch, turn signals, headlight switch, windshield wiper power, turn signal indicators (with bulb socket), high beam indicator (with bulb socket), dome lamp ground and power, neutral safety switch, stop light switch, dash indicator lamps, backup lamp switch, water temp gauge (with illumination sockets), oil pressure gauge (with illumination sockets), fuses, flashers, horn relay and emergency brake switch. ear harness, rear marker lights (with bulb sockets), rear lamp ground and tail light housing (4 wire).

NOTE: Harness #10110 is NOT equipped for computer controls nor is it engine specific. Water temp sender, oil gauge sender, alternator, starter solenoid, tach lead, ballast resistor and fuel tank sender are NOT pre-terminated.

Technical Details

  • Fits 1976 to 1986 CJ
  • Will not work on CJ8 Scrambler models
  • Almost every circuit on this harness is pre-terminated at both ends
  • All wires are color coded and labeled
  • All wire leads are pre-cut to proper lengths
  • OEM style bulkhead connectors
  • Blade type fuse block wiring is factory installed and machine crimped

Product Specs

Wire Coating
Standard

Customer Reviews

Average Customer Review
 

Questions & Answers