Jeep Parts Home » Jeep Interior Parts & Accessories » Jeep Antenna Mounts » Side Dash CB Mount Holder

Side Dash CB Mount Holder

Rugged Ridge | Part Number: RUG13551.09
  • Rugged Ridge - Side Dash CB Mount Holder  - Fits 1997 to 2006 TJ Wrangler, Rubicon and Unlimited - 4WD.com
Part Number: RUG13551.09
  • Technical Details

    • Fits 1997 to 2006 TJ Wrangler, Rubicon and Unlimited
    • Black powder coat
    • Lets you mount your CB to the dash board
    • Plate and microphone mounting plate

This innovative new mounting system lets you mount your CB to the open space just off to the side of your steering wheel. Locating the CB into this gap does not block your vision but allows for easy access to the CB controls. Each mounting bracket installs to existing dash mounts and is custom fit for TJ Wranglers so there is no drilling required. Each mounting bracket also includes an easy to use microphone mounting plate so your CB microphone stays out of the way while driving. CB mounting bracket not included (should be a part of the CB system). Limited three year warranty. Wont work with aftermarket Cage kits.

Installation instructions are in PDF format. You will need Adobe Reader to view these files.
Download Instructions

CB / Mount / Kit
Mount

Customer Reviews

Average Customer Review
2.0
 

It's OK...

3.0

By Heavy Trevy

from Williamsport, P

 

Comments about Rugged RidgeSide Dash CB Mount Holder:

The Rugged Ridge CB mount looks great and is very sturdy. Fitment isn't perfect, it angles out slightly. Easy install, but the screw for the mic mount is the WRONG size. Placement of the mic mount on the right side of the steering wheel makes the cord get tangled. I flipped my mic mount upside-down and used it on the left side. Though the mount looks great, I found after a couple weeks that the po

 

Good thought but poor design

1.0

By Vince

from Hawaii

 

Comments about Rugged RidgeSide Dash CB Mount Holder:

I am very disappointed with the engineering with this bracket. I had to bend it in two places in order to make it acceptable and it is over built so it was difficult to bend. The problem is that it is a single piece with only one 90 deg bend. The top of it is so large that puts a large amount of pressure on the plastic on your gauge cluster. when you tighten the screws (By the way the screws all h

Back to top
 

Questions & Answers

  • Q:

    Will this fit an 01 XJ??
Back to top